Applying Rowing Monitor Mount
Selecting the best adhesive and instructions for application
Remove old VHB tape from mounts
If the mounts came off your monitors and the tape is still on the mount, you should be able to peel off the VHB tape with your fingers to prep the mount for application
OR
Reach out to us for new mounts
Send an email to support@xboat.com detailing the failure and we’ll send you some replacement mounts
3M 1” VHB Tape vs. Gorilla Super Glue
VHB Tape is a good option if you’d like to have the option to remove the mounts at any point.
Gorilla Super Glue is a better choice if you are looking for the strongest bond between the monitor and the mount
Mount Application Instructions
- Cut two pieces of tape such that the mount back is fully covered with tape. The smaller piece will be about half the width of the tape.
OR for super glue start here
- Put six dots of super glue on the mount in the orientation shown in the image to the right.
- Apply the mount to the monitor centered horizontally and with the top of the mount even with the top of the Ulefone label
- Press firmly on the mount and hold for 10 seconds with VHB tape, 30 seconds for gorilla glue
Super glue is sticky! Use gloves and a protective material on the work surface to limit accidental gluing
Did this answer your question?
😞
😐
🤩